Description
The RMP was designed for modular organization on a rigid platform which can be secured in the lid, base, or walls of hard side cases among other applications. Quick access to your gear is enhanced by the consistent positioning and customizable layout. Inserted into any hard side case or vehicle, it gives you the tactical ability to organize your mission critical gear on an interchangeable platform that can be swapped out or quickly reorganized as the mission changes.
RMP Pelican 1620 Lid Organizer and Horizontal Cargo Area Gear Panel.
- Pre-drilled holes to line up with mounting points in lid of Pelican Case.
- Rigid Panel prevents sagging.
- Attach MOLLE style pouches to organize your gear.
- Customize with Adhesive Backed Loop to accept Velcro Hook Pouches.
- Use GMT backer plates to hard mount accessories.
- 0.25" holes on edge for mounting with screws.
- 1" slots for attaching 1" Webbing Mounting Straps and Handles.
Specifications:
- Width: 21.25"
- Height: 13"
- Thickness: 0.188"
- Material: High Strength Polyethylene
- Panel Weight: 17.25 ounces
Pelican & hard case compatibility.
- The 21.25in x 1in RMP is made to specifically fit the Pelican 1620 lid.
Mounting RMP to Pelican case lid:
- Molded Screw Mounting Points:
- Line up the pre-drilled holes on the panel with the molded mounting point and fasten with the "8 x 1/2" Pelican Case Mounting Screws".
- It is recommended to line up the top center hole and fasten with a screw there first.
- If there is a an issue with the holes not lining up perfectly a standard drill with a 0.125" or similar sized drill bit to create new mounting hole.
- Slick Lids with No Molded Screw Mounting Points:
- Many models of Pelican Case and other Hard Side protective cases do not have any molded mounting points. In this case we avoid using screws as it may pierce through the exterior of the case causing damage to the air/water tight nature of the case. Instead we specify using 3M Dual Lock adhesive backed tape (available on our site). In order to adhere to the very slick plastic of the hard side case as well as the RMP, we specify using the included 3M Primer 94 to prime all surfaces where 3M Dual Lock will adhere.
- Wipe surface to be adhered to (RMP and corresponding surface on Hard Case Lid) with an Alcohol Cleaning Wipe. Allow to completely dry.
- Apply 3M Primer 94 to RMP and Hard Case Lid where 3M Dual Lock will be adhered. Allow to tack up per directions supplied with 3M Primer 94.
- Peel and Stick 3M Dual Lock into place, use firm pressure to ensure 100% contact is achieved.
- Allow to dry over night and then snap RMP panel onto Lid of Case.