Description
The only no-drill mounting base for 2nd Gen Toyota Tacoma (2005-2011) that will hold your devices on tough 4x4 trails. Offroam mount base is custom designed to fit your Gen 2 Toyota Tacoma. The mount securely clamps the dash in your Toyota and it will not fall even on tough 4x4 trails. The clamp installs to your Taco without drilling or disassembling your dashboard - in less than 2 minutes! Offroam mounts are trusted by off-road enthusiasts & contractors.
- Does not block air flow.
- Holds light and heavy phones securely even on rough roads.
- Sturdy base, allows you to interact with your device without it moving.
- Simple installation requires no drilling, no sticky tape, no suction cups, no glue. Clamps attach to outer corners of the center air vents.
- Does not rattle, thanks to rubber liner that also protects the dash from marks.
- Does not obstruct windshield, the speakers, or mirrors.
- Precision machined from aluminium, hard anodized surface and stainless steel for rugged off-road use.
- Injection molded red silicone elastomer liner prevents scratches and damage to dashboard so you can remove your clamp without any marks.
Combine this mounting base with a phone holder and an extension arm for a complete phone mounting solution for your Toyota Tacoma.
Compatibility:
- Toyota Tacoma (2005-2015) - all trim levels.
- The clamp is designed for OEM Toyota Tacoma 2nd Gen dashboard only. It is not compatible with 3rd party dashboard modifications.
What's in the box:
-
1x Vehicle-specific mounting base.
1x Installation L-key.
Specifications:
-
Weight Capacity:
- Standard use: 2lbs (900gr).
- Heavy duty use: 1lbs (450gr).
-
Ball Size: 20mm.
- Air Vent Operation: Offroam Toyota Tacoma phone mount base does not block air flow. Air vent adjustment is restricted in up/down movement. The vent will remain open after installation. However, left/right will retain full range of motion. Symmetric design allows for installation on the left or right center air vent.
Materials:
-
Clamp: Precision machined / black anodized aluminum. Laser engraved logo
Ball: Precision machined / black anodized aluminum.
-
Hardware: black oxide stainless steel clamping screw.
- Liner: Molded red silicone protective liner.