ARB single, Blue Sea fuse box and Zamp Solar charge controller for a truly complete power system.
Zamp 5 Stage 10 Amp PWM Solar Charge Controller uses a large digital display showing volts, amps and amp over a period of time while LED lights show charging status and battery condition. Our digital deluxe 10 Amp Solar Charge Controller is designed to do it’s job with out the need for maintenance but it also is feature rich to monitor and indicate system functions. It supports, and is programmable for 4 typical types of deep cycle batteries (WET, GET, AGM and Calcium) as well as lithium batteries (LTO and LifeP04).
The ARB/Solar PowerTray features a Blue Sea 6 circuit fuse block which gives you the added ability to wire in your aftermarket accessories.
This product is for the ARB / Solar PowerTray Mounting Platform, Support Leg, and mounting hardware.
It does not include the Switch-Pros, ARB, Blue Sea accessories, Power/Ground Cables, etc.
- ARB air coupler relocation kit.
- ARB single compressor.
- ARB air up kit.
- Zamp solar charge controller.
- 1/8th Inch 5052 Aircraft Aluminum - Possibly a little overkill to use for mounting electrical accessories that tend to weigh in the ounces, not pounds. But with a weight coming in at 3X lighter than steel and corrosion resistance far superior to even stainless steel, aluminum is the clear choice for weathering the harsh conditions we put our vehicles though.
- Waterjet manufacturing - Guarantees precise cuts with an accuracy of ±0.003", which is why it is used globally in many industries for intricate designs and jobs which require high tolerances.
- Chamfered edges - This is the only step where we cut corners (hehe). To avoid sharp edges we chamfer all jagged edges and corners by hand with a specialized high-speed router bit. So you don't have to worry about cutting your hands or scratching your vehicles paint during installation. Also with a 45° chamfer on the edges you minimize the risk of vibration wearing though the protective sleeving on cables and wires which would short out the circuit.
- Perfect fit - Don't sacrifice access to your factory fuse block with other mounts! Each PowerTray is designed around your factory components.
- Unparalleled stability - Utilizing three points of contact, you can be sure that your valuable electronics are safe and supported by including an additional support leg that secures the far-side of the tray to the lower inner fender.
- High Quality JIS Class 10.9 Steel Hardware - Your entire Toyota is built with JIS (Japanese industrial standard) hardware so why should your aftermarket parts be any different.
- Power Made Easy - Delivered right to your door with step-by-step installation instructions.
This PowerTray will fit the following vehicles:
- Toyota FJ cruiser 2007-2014 with automatic transmission.
- Unfortunately manual transmission FJ's have a clutch fluid reservoir mounted in the same location the PowerTray is designed to install. So if your FJ has a manual transmission then shoot us an email with pictures of the reservoir and please include vehicle info like year, make, and model so we can go over options for relocating the reservoir.
- Note: FJ cruiser's with the rear 400w inverter may have a small relay box bolted to the fender that will need trimmed.
- Toyota 5th Gen 4Runner's 2002-Current.
- Note: 2020+ 4Runners have an additional relay/fuse box located on the fender that will need to be relocated closer to the cab of the vehicle in order to install this PowerTray.
- Lexus GX470 2002-2009 and GX460 2010-Current.
- Note: These vehicles may have a plastic vanity cover that will need to be removed and discarded. But nothing should actually hinder installation.