The VLR is by far the cleanest and safest way to add load to any vehicle lighting system. With the included DuoTap Harness splicing the VLR into your factory wiring doesn’t get any easier. Simply position the wires and click the DuoTap closed with a pair of pliers.
We get asked all the time, how many resistors will I need? The answer is simple: If you're removing a filament turn signal bulb add one VLR-6 in its place. It's like balancing a scale; if you remove weight, the scale will be unbalanced, so you're simply putting the same amount of weight (load) back on.
The VLR is by far the cleanest and safest way to add load to any vehicle lighting system. VLR resistors accomplish the same task as a common gold resistor but are easier to install, have a lower profile, and run 50% cooler (250°F MAX).
Using a wire wound resistor potted inside of a black anodized aluminum heat sink, these are the most weatherproof and thermally safe resistors on the market. VLR resistors use high temp silicone wiring attached to a male waterproof circular connector.
The supplied VLR High Temp mounting tape can be used to adhere the resistor body to a flat, clean metal surface on the vehicle. As an extra precaution: VLR resistors should be mounted out of harm's way and should not touch any plastic or other wiring.
For exterior applications, we recommend filling the DuoTap with our dielectric grease.
- 2x VLR-6 Resistor
- 2x DUO_TAP Harness
- 2x 3M Mounting Tape